problem with end stop and screen

Exposez ici vos problème techniques matériels
Jeando
Nouveau membre
Messages : 6
Inscription : ven. mars 11, 2016 4:17 pm
Imprimante 3D : Bq prusa i3 hephestos
Localisation : Cazals, Lot, France

LCD screen become blank when any axis hit the end stop on bq prusa i3, after intallings a new ramps 1.4 from premium computers.
Jeando
Avatar de l’utilisateur
Jacques
Site Admin
Messages : 5616
Inscription : jeu. oct. 23, 2014 3:02 pm
Imprimante 3D : Witbox, Witbox 2 et Hephestos
Localisation : Aix en Provence
Contact :

Renversez le sens des connecteurs, de vos end-stop, il est probable qu'un court-circuit se produise à la fermeture de ceux-ci si votre câblage n'est pas conforme à la RAMPS.
On the ramps the external pin is the signal pin (yellow). If you reverse the connector, the result is short circuit between + and - which explains the lcd down.
Swramps.JPG
Swramps.JPG (21.77 Kio) Consulté 1986 fois
Des idées d'améliorations https://www.thingiverse.com/Premium/designs
Une question, une précision, un manque de pièces détachées, posez vos questions ici même.
Répondre