Faux aussi car il tente de monter la tête à 200mm alors que la machine ne peut aller qu'a 180mm, c'est gênant pour les puristes...
Sebastien a modifié celui-ci pour le rendre plus efficace
Code : Tout sélectionner
;End GCode
M104 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.5 E-5 X-20 Y-20 F{travel_speed} ;move Z up a bit and retract filament even more
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
M84 ;steppers off
G90 ;absolute positioning
;{profile_string}
Pour l'utiliser il faut copier le code ci-dessus et remplacer celui qui est en place (attention à l'onglet, il s'agit du end G-code et non du start) ensuite, vous pouvez le sauvegarder comme nouveau profil d'impression.